Primer Sealer Undercoat

Applications

New or Bare Surfaces :

New or Bare surfaces must be clean, dry and free from efflorescent salts. Remove all loose, defective or poorly adhering material by rubbing down using a suitable abrasive paper or stiff fiber brush and dust off. Treat any areas affected by mould, lichens, algae and moss with bleach. Apply a priming coat of Primer Sealer Undercoat. Allow the primer to dry for 2-3 hours.

Previously painted sounded surfaces:

Remove all loose, defective or poorly adhering material by rubbing down using a suitable abrasive paper or stiff brush and dust off. Apply one coat of Primer Sealer Undercoat and allow to dry for 2-3 hours.

Defective Surfaces:

Surface with cracks or broken areas must be levelled first and polished prior to undercoat sealer application. Holes & cracks must be fulfilled with a mixture of sand & cement. Apply one coat of Promax Primer Sealer Undercoat and allow to dry for 2-3 hours.

Application:

Promax Primer Sealer Undercoat se can be applied by thinning (1:1) with water by volume for brush application (depend on surface absorbency.

Benefits

Information and Care

Environmental Health and Safety

• Avoid contact with eyes and prolonged or repeated contact with skin.
• Use only sufficient ventilation during application and drying.
• Do not breathe spray mist or sanding dust.
• If swallowed, it may cause serious damage.
• Use dust mask during application, sanding and clean up.
• Wash thoroughly after handling.
• In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
• Close container after each use.
• In case of skin contact, immediately wash skin with soap and plenty of water. Get medical attention if irritation develops or persists
• When empty, don’t use its container for edible storage.

After Painting Care

• Remove all dirt using a clean cloth or duster. Always remove dirt from top to bottom. This helps in avoiding loose dirt blotch the walls.
• For household marks like pencil,tea,coffee,crayons,turmeric,ketchup,sketch pen etc. use liquid dish wash/mild detergent solution. Use a sponge to remove the stains. Wipe the area with a clean cloth.
• Walls in children’s rooms get dirty faster than the rest of the house. Repainting with a single coat of paint every two years will keep the surface looking fresher. Make sure old paint is sanded lightly before the new coat is painted on.
• Walls of passages, kitchens and children’s rooms are easily soiled. Clean these areas regularly at least once a month on a specific day with a sponge and mild soap solution. Do not scrub unnecessary as that might damage the paint film. However, highly washable paints usually have good scrub resistance.