Silicone Weathershield

Applications

New or Bare Surfaces :

New or bare surfaces must be clean, dry and free from efflorescent salts. Remove all defective or poorly adhering material by using a suitable abrasive paper or stiff brush and dust off. Treat any area affected by mould, lichens & algae with bleach. After priming new surfaces with Promax Primer Sealer Undercoat, fill the surfaces with Promax Excellent Wall Filling.

Previously painted sounded surfaces:

Remove all defective or poorly adhering material by rubbing it down using a suitable abrasive paper and dust off. Spot prime and fill the surface as described above if required.

Powdery dusty surfaces, cracks & other surface defects :

Make good minor defects. For large holes and cracks, use sand and cement mixture. Allow drying. Prime surface and then fill any surface imperfection with Promax Excellent Wall Filling as described above. For best results apply one coat of Promax Primer Sealer Undercoat over wall putty & dry overnight.

Finishing :

Apply 2-3 coats of Promax Silicone Weathershield at intervals of 2-3 hours between Coats. Stir thoroughly before use. The thinning ratio must be followed as per the application procedure.

Benefits

Information and Care

Environmental Health and Safety

• Avoid contact with eyes and prolonged or repeated contact with skin.
• Use only sufficient ventilation during application and drying.
• Do not breathe spray mist or sanding dust.
• If swallowed, it may cause serious damage.
• Use dust mask during application, sanding and clean up.
• Wash thoroughly after handling.
• In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
• Close container after each use.
• In case of skin contact, immediately wash skin with soap and plenty of water. Get medical attention if irritation develops or persists
• When empty, don’t use its container for edible storage.

After Painting Care

• Remove all dirt using a clean cloth or duster. Always remove dirt from top to bottom. This helps in avoiding loose dirt blotch the walls.
• For household marks like pencil,tea,coffee,crayons,turmeric,ketchup,sketch pen etc. use liquid dish wash/mild detergent solution. Use a sponge to remove the stains. Wipe the area with a clean cloth.
• Walls in children’s rooms get dirty faster than the rest of the house. Repainting with a single coat of paint every two years will keep the surface looking fresher. Make sure old paint is sanded lightly before the new coat is painted on.
• Walls of passages, kitchens and children’s rooms are easily soiled. Clean these areas regularly at least once a month on a specific day with a sponge and mild soap solution. Do not scrub unnecessary as that might damage the paint film. However, highly washable paints usually have good scrub resistance.